Page Comparison

Info
Depending on the configuration and following revisions, the features of the board are subject to change. For detailed information on hardware specifications, please visit www.seco.com

INDEX

Component	Description	Use	Default configuration (Fig.1)
JP14		Set no jumper to enable M.2 on CN11 Set jumper 1-2 to disable M.2 on CN11	Unplugged
JP15			Unplugged
JP13		Set no jumper to disable eDP-to-LVDS CONV Set jumper 1-2 to enable eDP-to-LVDS CONV	Unplugged
JP1		Set no jumpers to enable M.2 on CN12 Set jumper 1-2 to disable M.2 on CN12	Unplugged
JP2			Unplugged
JP3	COM1	Set no jumper for RS-485 Set jumper 1-2 for RS-422 Set jumper 2-3 for RS-232	Unplugged
JP4	COM2	Set no jumper for RS-485 Set jumper 1-2 for RS-422 Set jumper 2-3 for RS-232	Unplugged
JP16	PANEL BACKLIGHT VOLTAGE	Set jumper 1-2 for 12V Set jumper 2-3 for 5V	2-3 Plugged
JP17	PANEL VDD VOLTAGE	Set jumper 1-2 for 5V Set jumper 2-3 for 3.3V	2-3 Plugged
JP10	PANEL INTERFACE	Set no jumper for LVDS Set jumper 1-2 for eDP	Unplugged
JP12	BIOS_DIS1	Set JP11 and no JP12 for SPI on carrier Otherwise for SPI on module	Unplugged
JP11	BIOS_DIS0		Unplugged
JP9	VDD_EN Level	Set no jumper for 3.3V Set jumper 1-2 for 5V	Unplugged
JP8	BKLT_EN Level	Set no jumper for 3.3V Set jumper 1-2 for 5V	Unplugged
JP6	BKLT_CTRL Level	Set no jumper for 3.3V Set jumper 1-2 for 5V	Unplugged
JP5	GPIO/SD	Set no jumper for GPIO set jumper 1-2 for SD CARD	Plugged

_{Fig. 1:}_{Description of jumpers possible configuration}

Further information about placement and description of connectors are available here.

Versions Compared