Page Comparison

...

1. Make sure there is no microSD card inserted in the slot J17 of the E09SBC-3.5-RK3568.

2. Connect your Linux Host PC to the microUSB connector J48 of the E09SBC-3.5-RK3568.

3. Turn on the switch SW1.

4. Power on the E09 SBC-3.5-RK3568 board.

5. Turn the switch SW1 back off.

6. Run the command rkdeveloptool ld to make sure the E09 board is detected.

7. Flash the loader on the SBC-3.5-PX30 RK3568 device via the following command:

   Code Block
   $ sudo rkdeveloptool db loader.bin

8. Flash the .wic image in the board via the following command. Remember to substitute the <image-file>.wic with the file name of the image (e.g seco_rk3568_e09_edgehog-embedded-full-image-wayland_5-10-x_kirkstone_1-03-00_20240410.wic):

   Code Block
   $ sudo rkdeveloptool wl 0 <image-file>.wic

9. Wait for it to finish, then disconnect the microUSB cable and reboot the board. The E09 SBC-3.5-RK3568 board will now run the new image.