Page Comparison

...

1. Make sure there is no microSD card inserted in the slot J17 of the E09.

2. Connect your Linux Host PC to the microUSB connector J48 of the E09.

3. Turn on the switch SW1.

4. Power on the E09 board.

5. Turn the switch SW1 back off.

6. Run the command rkdeveloptool ld to make sure the E09 board is detected.

7. Flash the loader on the SBC-3.5-PX30 device via the following command:

   Code Block
   $ sudo rkdeveloptool db loader.bin

8. Flash the .wic image in the board via the following command. Remember to substitute the <image-file>.wic with the file name of the image (e.g seco_rk3568_e09_edgehog-embedded-full-image-wayland_5-10-x_kirkstone_1-03-00_20240410.wic):

   Code Block
   $ sudo rkdeveloptool wl 0 <image-file>.wic

9. Wait for it to finish, then disconnect the microUSB cable and reboot the board. The E09 board will now run the new image.