• In progress

    • JTAG Support for Trizeps Modules

    Owned by Anu Selvaraj (Deactivated)
    Last updated: 26. Oct 2022
    1 min read

    The processor is powered by +3.3V. Never try to source inputs when power is switched of ! Never apply signal levels higher than +3.3V !
    Note that the Trizeps warranty will be lost if another cable than the original Seco JTAG cable is used !

    A JTAG-cable with a similar schematic as here can be ordered:

    In case that you switch off power during a bootloader update, you can recover the bootloader with a JTAG Cable which can be delivered on request. The JTAG cable uses a parallel port and the software runs with Windows 2000 or Windows XP. Note that you need to install a special driver to gain direct parallelport acces (giveio.sys).

    The software can be downloaded here. For more instructions please study the included *.html document.

    JFlash Support for Trizeps