CN11

Set jumper 1-2 for TYPE mode Set jumper 2-3 for no TYPE/AT mode

1-2 Plugged

J2

Set jumper 1-2 for ATX mode
Set jumper 2-3 for AT mode

1-2 Plugged

CN6

Set jumper 1-2 for battery disconnected
Set jumper 2-3 for battery connected
Set no jumper for RTC current measurement

2-3 Plu

JP2

The power consumption on +5V_ALW can be monitored by removing 2 way jumper JP2 and inserting a tester set as a meter.

Plugged

CN3

Set jumper 1-2 for PSU PWR_OK
Set jumper 2-3 for PWR_OK always high

1-2 Plugged

JP12

PANEL BACKLIGHT VOLTAGE SELECTION

Set jumper1-2 for 12V
Set jumper 2-3 for5V

2-3 Plugged

JP13

PANEL VDD VOLTAGE SELECTION

Set jumper 1-2 for 5V
Set jumper 2-3 for 3.3V

2-3 Plugged

JP11

PANEL INTERFACE SELECTION

Set jumper for eDP
Set no jumper for LVDS

Unplugged

JP8

BIOS_DIS1

Set JP8 and no JP7 for SPI on carrier
Otherwise for SPI on module

Unplugged

JP7

BIOS_DIS0

Unplugged

JP10

GPIO/SD

Set no jumper for GPIO
Set jumper for SD CARD

Plugged

JP5

COM1

Set no jumper for RS-485
Set 1-2 for RS-422
Set 2-3 for RS-232

Unplugged

JP6

COM2

Set no jumper for RS-485
Set 1-2 for RS-422
Set 2-3 for RS-232

Unplugged

JP4

ESPI/LPC# SELECTION

Set jumper for switch enabled
Set no jumper for switch disabled

Plugged

JP3

LPC_RST#

when jumper JP3 is inserted, this signal is derived by CB_RESET# signal or simply by biasing it using a Ultra High Speed CMOS buffer. When jumper JP3 is not inserted, this signal is derived by an eSPI to LPC bridge placed on carrier board

Plugged

JP14

MIC#_SEL

Set no jumper for MIC2
Set jumper for MIC1

Plugged

JP9

3-WIRES/4-WIRES FAN TACH DRIVER

Set jumper 1-2 for 4-wires fan
Set jumper 2-3 for 3-wires fan

1-2 Plugged

JP1

Set jumper for BATLOW# enabled
Set no jumper for BATLOW# disabled

Unplugged