This describes the WLAN-driver of Trizeps4-WL-module.
View also kwlantool and Trizeps IV WL EEPROM Configuration.
Registry Keys
| ||
|---|---|---|
Key | Type | Description |
RtsThreshold | DWORD | RTS threshold in bytes. |
FragThreshold | DWORD | Fragmentation threshold in bytes. |
GpioIndication | DWORD | set to 0. |
TxRetryCount | DWORD | Number of tries to send a packet. |
Preamble | DWORD | 0:Long preamble; 1:Short preamble. |
AllowedChannels | hex | WLAN-channels to use: 1..14. This is the scan-sequence. |
ScanAllBss | DWORD | Set to 1 to scan for both: Ibss(Ad-Hoc) and Infrastructure(Access-Points). |
PassiveScan | DWORD | Set to 1 to do passive scanning (Only listen to beacons). Set to 0 to do active scanning (send probe request). |
ProbeDelay | DWORD | Delay in ms to be used prior to transmitting a probe frame during active scanning. |
MinScanTime | DWORD | Minimum Time in ms to scan a channel. |
MaxScanTime | DWORD | Maximim Time in ms to scan a channel. |
Desired Rate | DWORD | Desired rate to be used for a connection in 0.5MB/s. |
DesiredChannel | DWORD | This is the desired channel to use. 0: Use channel information from scan. |
DesiredIBSSChannel | DWORD | Preferred IBSS channel number to use for AdHoc-connections. |
BeaconListenInterval | DWORD | The Listen Interval (expressed in units of Beacon Interval) is used to indicate to the AP how often a station wakes to listen to beacon management frames. 0..16. |
BeaconPeriod | DWORD | Beacon period of the BSS. |
SupportRoaming | DWORD | Enable support of the bgw211-firmware to support local roaming. |
Roaming | DWORD | Enable roaming using the bgw211-driver. |
RoamingIntervalNoSignal | DWORD | Time before two roaming-scans, when no signal detect or connection lost. |
RoamingIntervalVeryLow | DWORD | Time before two roaming-scans, on very-low signal-strength. |
RoamingIntervalLow | DWORD | Time before two roaming-scans, on low signal-strength. |
RoamingIntervalGood | DWORD | Time before two roaming-scans, on good signal-strength. |
RoamingIntervalVeryGood | DWORD | Time before two roaming-scans, on very-good signal-strength. |
RoamingIntervalExcellent | DWORD | Time before two roaming-scans, on excellent signal-strength. |
JoinTimeout | DWORD | Timeout in ms to join a wlan-network. |
DoScanOnConnect | DWORD | Set to 1 to scan for access-point, before trying to connect. |
DPTAMode | DWORD | 0: DTPA off, 1:DTPA on. If DTPA is on, the tx-power will be lowered if sufficient link conditions are detected. |
LinkAdaption | DWORD | Use link adaption. |
ReportCipher | DWORD | 0x1: Report AES and TKIP, 0x2: Copy RSN-IE (WPA2), 0x4 Copy WPA-IE (WPA) from AccessPoint. |