Page Comparison

...

The Trizeps6 can show a splash - screen during the device device’s start. The Windows CE OS - image can then take the display - parameters from this splash - screen. This allows an easy change of the display, without the need to modify the Windows CE OS - image.

See BitmapBoot Tool ( Trizeps II - V) if you want to show a BootBitmap on Trizeps2,3,4 or 5.

...

• The bitmap to be shown.

• A script that includes the display - settings.

Creation of the Bootlogo

...

The parameter names are the same as in the registry ( Display Parameters).
With the bootloader-command display, the display-controller is initialized with the current settings. boot nanddisk wince.bmp loads a picture with the name wince.bmp into the current framebuffer. The last two lines are specific to the ConXS and enable the backlight. When using a Trizeps6 without WLAN/BluetoothBT, replace the last two lines with:

...

The script can be run from SD-card. The boot-picture may also reside there.
If you want to store it to the internal boot-partition follow these steps:

1. Create a autoboot.bat ( see Display-Script).

2. Create a boot-picture ( i.e. wince.bmp).

3. Store both files on a SD-Card.

4. Plug SD-Card and enter bootloader:

5. Remove previous boot-script and picture ( i.e. with del autoboot.bat and del wince.bmp)

6. Run store mmc autoboot.bat autoboot.bat

7. Run store mmc wince.bmp wince.bmp

Note that the filenames should not be longer than 8 characters and do not begin with a number!!