...
ConXM Carrierboard
12-24V 1000mA Power supply
USB-A to micro-USB -A cable
Serial cable (Debug)
Acrylic stand (Frame)
SD-Card with OS
...
Features
Vin 12V-24V DC
Li-Ion/Lipo Battery
2x USB Host/ 1x USB-OTG
10/100 MBit Ethernet
Audio ( Speaker, Stereo Headphone, 3 x Microphone, FM Antenna)
LVDS-Display , HDMI
MIPI high speed( Display, Camera 4ch, Camera 2ch, SPI, I2C, GPIO)
UART,SPI,I2C,GPIO, Camera Control (low speed)
...
In general the Eval-Kit is pre-configured and tested with the OS you ordered. The default jumper settings are set to your configuration.
Please check if all connections are correct.
...
Connect the baseboard to a computer using a serial cable and a serial adapterthe USB-A to micro-USB cable.
You will need a Tera Term application to communicate with the device.
In Tera Term configure the serial connection in Setup-> Serial Port. Set the following settings:
Port: serial port, to which device is connected
Speed: 115200
Data: 8bit
Parity: none
Stop bits: 1
Plug the power connector in, the device will boot up, you should see the terminal output if settings are correct, and correct port is selected.
Links
ConXM (Carrier-Myon-ConXM , formerly: dragonBase)
Myon II (SOM-Myon-II-MX8M-Mini)
...