Eval-Kit Specification (without Myon II)
ConXM Carrierboard
12-24V 1000mA Power supply
USB-A to USB-A cable
Serial cable (Debug)
Acrylic stand (Frame)
SD-Card with OS
Features
Vin 12V-24V DC
Li-Ion/Lipo Battery
2x USB Host/ 1x USB-OTG
10/100 MBit Ethernet
Audio ( Speaker, Stereo Headphone, 3 x Microphone, FM Antenna)
LVDS-Display , HDMI
MIPI high speed( Display, Camera 4ch, Camera 2ch, SPI, I2C, GPIO)
UART,SPI,I2C,GPIO, Camera Control (low speed)
Software (OS Images)
OS | Bootloader | Kernel | Release Date | Download | |
|---|---|---|---|---|---|
| 1 | Debian 10.3 | 2020.04 / kuk_imx_v2020.04 | 5.10 / kuk_lf-5.10.y_android-compilable | 2023-05-04 | |
| 2 | Yocto 5.10 Hardknott-Weston-Chromium | 2020.04 / kuk_imx_v2020.04 | 5.10 / kuk_lf-5.10.y_android-compilable | 2023-05-04 |
Initial Setup
In general the Eval-Kit is pre-configured and tested with the OS you ordered. The default jumper settings are set to your configuration.
Please check if all connections are correct.
If needed prepare everything for debug connection by using connector U12. ( for details next chapter)
Plug in the power adapter into the 12V Jack (J17) and 120VAC~240VAC to power source.
The system will start up and OS will be visible on the Display. The Boot messages are printed within the PC terminal window.
Establish a Serial Connection
Connect the baseboard to a computer using a serial cable and a serial adapter.
You will need a Tera Term application to communicate with the device.
In Tera Term configure the serial connection in Setup-> Serial Port. Set the following settings:
Port: serial port, to which device is connected
Speed: 115200
Data: 8bit
Parity: none
Stop bits: 1
Plug the power connector in, the device will boot up, you should see the terminal output if settings are correct, and correct port is selected.
Links
ConXM (Carrier-Myon-ConXM , formerly: dragonBase)