SBC-3.5-PX30 (D23)

SBC-3.5-PX30 is a Single Board Computer in 3.5” form factor (which is 146 x 102mm) based on embedded Rockchip PX30 Processor, featuring Quad-Core ARM® Cortex®-A35 processor. Graphics features of the board are managed directly by the processor, which integrates a Mali-G31 GPU with High performance dedicated 2D processor, supporting OpenGL® ES 1.1 / 2.0 / 3.2, Vulkan 1.0, OpenCL 2.0 and Open VG 1.1. The board is completed with up to 4GB LPDDR4-3200 32-bit bus memory directly soldered on board and one eMMC 5.1 Flash Drive with up to 64GB of capacity. Mass storage capabilities are completed by an optional microSD Card slot. The board incorporates also HDMI Technology, audio peripherals and different additional slots, such as miniPCI-e and M.2 to expand its capabilities.

For ordering purposes, the SBC-3.5-PX30 is referred to by its base code, “D23”.

INDEX

How can I power on my module?

SBC-3.5-PX30 board can be supplied with any voltage in the +12VDC ÷ +24VDC range (recommended voltage range) via the Mini-Fit power in connector (CN44).

You can find more hardware info regarding the SBC-3.5-PX30 in the technical user manual.

What will I find in my module?

Off-the-shelf products are shipped with a standard in-house-developed software.
The definition of standard, in this case, is “the environment which SECO adopts for validation”.
Anyway, custom in-house-developed software with different defaults can be built.
Contact your reference sales for further information.

What can I do now?

Downloads

Edgehog OS

Starting from Linux Kernel version 5.10, the Board Support Package (BSP) for this board is fully integrated within Edgehog OS, the operating system for the All-In-One IIot platform CLEA developed by SECO and based on Yocto. Edgehog OS is intended to provide the highest standards in terms of security and stability thanks to features like OTA (Over the Air) updates, double partitions, and fallback procedures. Edgehog OS integrates a Device Manager to communicate with the Cloud and allows a family of products to be managed as a fleet.

Source code:

The source code for Edgehog OS can be found at the following link.

Binaries:

The binaries (U-Boot, Linux Kernel, Yocto image) associated with the various Edgehog OS releases can be found at the following page: Edgehog Releases.

Legacy Software

This section contains releases (source code) for legacy BSPs Yocto.

Source code:

Source code for Linux Kernel and U-Boot is available here.

The instructions to flash binaries in a bootable device can be found here