Eval-Kit Specification (Excluding SOM-SMARC-Genio700)
1pc of RB79-0000-0000-I2 (Carrierboard)
1pc of CV-904/20REVB (Serial adapter-cable for SA44)
1pc of CV-874/20 (Power adapter-cable)
1pc of 4026241M1X030 (Battery Lithium CR2032 3V 210mAh)
1pc of CV-890/10 (Power supply + adapter)
1pc of FN070PGRGUL037C (Display)
1pc of CV-1408/750 (LVDS cable)
1pc of CV-1392/530 (USB cable for Touch)
Features
eMMC (up to 64 GByte)
Up to 2x 1Gbit Ethernet
TPM
1x USB 3.1, 2x USB 2.0
MIPI/eDP, HDMI/DP
RTC
EEPROM
WLAN 802.11 a/b/g/n/ac and BT 5.3 Combo module (M.2 1216)
Software (OS Images)
OS | Bootloader | Kernel | Release | Download |
|---|---|---|---|---|
Ubuntu (Jammy Jellyfish) |
|
| Ubuntu 22.04.2 LTS | |
Ubuntu (Jammy Jellyfish) |
|
| Ubuntu 22.04.2 LTS | |
Ubuntu (Jammy Jellyfish) |
|
| Ubuntu 22.04.2 LTS |
Initial Setup
To begin, mount the SOM-SMARC-Genio700 or SOM-SMARC-Genio510 Module into the Baseboard, insert the battery into the battery socket, and connect the LVDS cable to the Display and CN14 of the Baseboard. Then, connect the power cable to the baseboard and set up the USB Touchscreen connection. The OS is stored on the µSD card, which should be placed in CN77. If not, a list of available images for download can be found in the Software section.
The Eval-kit comes with a power supply including an adapter designed for this evaluation system.
You can now proceed to power up the system.
Establish a Serial Connection
Connect the baseboard to a computer using the USB-A to micro-USB cable.
Ensure you have the Tera Term application to communicate with the device.
In Tera Term, configure the serial connection in Setup-> Serial Port with the following settings:
Port: serial port connected to the device
Speed: 115200
Data: 8bit
Parity: none
Stop bits: 1
Plug in the power connector, allowing the device to boot up. If the settings are correct and the right port is selected, you should see the terminal output.