| Table of Contents |
|---|
Eval-Kit
...
Specification (Without Trizeps Module)
Frame with Baseboard pConXS III and Display
12-24 V power supply
Acrylic stand
USB-A (male to male) cable
Serial cable
Suggested Software
...
Features
Vin 12V-24V DC
VIN_FUSED Supply and Power failure GPIO for USV
2x USB Host/ 1x USB-OTG
10/100 MBit Ethernet
Audio (Stereo Headphone, Microphone , Line-In, Speaker out)
LVDS-Display , HDMI, RGB
UART, RS-232, CAN, SDIO, I2C
Software (OS Images)
Trizeps VIII Mini
Bootloader | Kernel | Release | Download | |
|---|---|---|---|---|
Windows 10 IoT Enterprise | BSP 1-4-0 | 1-4-0 2023-04-11 | ||
Android | ||||
Debian 12 | 2020.04 / kuk_imx_v2020.04 | 2024-03-26 | ||
Debian 10.3 | 2020.04 / kuk_imx_v2020.04 | 5.10 / kuk_lf-5.10.y_android-compilable | 2023-05-26 | |
Yocto | 2020.04 / kuk_imx_v2020.04 | 5.10 / kuk_lf-5.10.y_android-compilable | 2023-05-30 |
Trizeps VIII Plus
Bootloader | Kernel | Release | Download | |
|---|---|---|---|---|
Windows 10 IoT Enterprise | ||||
Android | ||||
Debian 12 | 2020.04 / kuk_imx_v2020.04 | 2024-03-26 | ||
Yocto | 2020.04 / kuk_imx_v2020.04 | 2024-04-28 | trizeps8plus-pconxs-v3-hardknott_weston_chromium-20230428.imz |
Initial Setup
In general the Eval-Kit is pre-configured and tested with the OS you ordered.
Please check if all connections are correct.
If needed prepare everything for debug connection by using connector U12. ( for details next chapter)
Plug in the power adapter into the 12V Jack (J17) and 120VAC~240VAC to power source.
The system will start up and OS will be visible on the Display. The Boot messages are printed within the PC terminal window.
Establish a Serial Connection
Connect the baseboard to a computer using a serial cable and a serial adapter.
You will need a Tera Term application to communicate with the device.
In Tera Term configure the serial connection in Setup-> Serial Port. Set the following settings:
Port: serial port, to which device is connected
Speed: 115200
Data: 8bit
Parity: none
Stop bits: 1
Plug the power connector in, the device will boot up, you should see the terminal output if settings are correct, and correct port is selected.
Build u-boot
Trizeps 8 Mini
Links
How-To (pConXS III)
...
...
...
Linux
...
Windows 10 IoT Enterprise (Trizeps 8 Mini)
How to deploy Windows 10 IoT Enterprise to Trizeps VIII Mini / Trizeps VIII Plus