ConXM with Myon II

Eval-Kit Specification (without Myon II)

• ConXM Carrierboard

• 12-24V 1000mA Power supply

• USB-A to USB-A cable

• Serial cable

• Acrylic stand (Frame)

• SD-Card with OS

Features

1. Vin 12V-24V DC

2. Li-Ion/Lipo Battery

3. 2x USB Host/ 1x USB-OTG

4. 10/100 MBit Ethernet

5. Audio ( Speaker, Stereo Headphone, 3 x Microphone, FM Antenna)

6. LVDS-Display , HDMI

7. MIPI high speed( Display, Camera 4ch, Camera 2ch, SPI, I2C, GPIO)

8. UART,SPI,I2C,GPIO, Camera Control (low speed)

Software (OS Images)

Initial Setup

Establish a Serial Connection

1. Connect the baseboard to a computer using a serial cable and a serial adapter. 

2. You will need a Tera Term application to communicate with the device.

3. In Tera Term configure the serial connection in Setup-> Serial Port. Set the following settings:

   • Port: serial port, to which device is connected 

   • Speed: 115200 

   • Data: 8bit 

   • Parity: none 

   • Stop bits: 1 

4. Plug the power connector in, the device will boot up, you should see the terminal output if settings are correct, and correct port is selected. 

Links