Getting Started with pConXS III

Eval-Kit Contents

• 12-24 V power supply 

• Acrylic stand

• USB-A (male to male) cable

• Serial cable and serial adapter

Suggested Software

• http://www.teraterm.org/

• USB Image Tool

Access via Serial Interface

1. Connect the baseboard to a computer using a serial cable and a serial adapter. 

2. You will need a Tera Term application to communicate with the device.

3. In Tera Term configure the serial connection in Setup-> Serial Port. Set the following settings:

   • Port: serial port, to which device is connected 

   • Speed: 115200 

   • Data: 8bit 

   • Parity: none 

   • Stop bits: 1 

4. Plug the power connector in, the device will boot up, you should see the terminal output if settings are correct, and correct port is selected. 

Managing Bootloader

Instructions on how to make, update and operate the U-Boot bootloader for different modules

Managing Linux Kernel

Instructions on how to make and update the Linux kernel for different modules

Deploying Images

Instructions for other operating systems can be found in their sections in Operating Systems.

Updating Device Tree