Downloads

27.03.2024

Module – Baseboard	Link

Module – Baseboard	Link
Trizeps 8 Mini – i-PAN T7 II	seco_tr8mini-ipant7_bookworm_20240327.img.xz
Trizeps 8 Mini – pConXS III	seco_tr8mini-pconxs_bookworm_20240326.img.xz
Trizeps 8 Plus – i-PAN T7 II	seco_tr8plus-ipant7_bookworm_20240327.img.xz
Trizeps 8 Plus – pConXS III	seco_tr8plus-pconxs_bookworm_20240326.img.xz

Module – Baseboard	Link

Module – Baseboard	Link
Trizeps 8 Mini – i-PAN T7 II	seco_tr8mini-ipant7_bookworm-20231026.img.xz
Trizeps 8 Mini – pConXS III	seco_tr8mini-pconxs_bookworm-20231026.img.xz
Trizeps 8 Plus – i-PAN T7 II	seco_tr8plus-ipant7_bookworm-20231026.img.xz
Trizeps 8 Plus – pConXS III	seco_tr8plus-pconxs_bookworm-20231026.img.xz

Choose and download the correct .img.xz file for your module and baseboard (these images already have the correct device tree pre-installed).
Establish the Serial Connection.
Connect the baseboard to your computer using provided USB-A (male to male) cable via the USB-OTG port (the one closer to the PCB) of the baseboard.
Enter the U-Boot by holding the Esc button in the Tera Term while the device powers on. (You can use the reset button on the back of the baseboard).
Execute the command, that will configure the USB-OTG port to emulate a USB-Mass-Storage device.
u-boot=> ums 0 mmc 0
You will see the following output:
Open the https://etcher.balena.io/,
select correct image archive, Linux UMS disk 0 USB Device as target and press Flash.
After the confirmation of the successful operation, you can unmount the device from computer.
Press Ctrl+C in Terminal window.
Restart the device.
u-boot=> reset