ConXM with Myon-II-MX8M-Mini
- Michael Schieren
Eval-Kit Specification (without Myon II)
ConXM Carrierboard
12-24V 1000mA Power supply
USB-A to micro-USB cable
Serial cable (Debug)
Acrylic stand (Frame)
Features
Vin 12V-24V DC
Li-Ion/Lipo Battery
2x USB Host/ 1x USB-OTG
10/100 MBit Ethernet
Audio ( Speaker, Stereo Headphone, 3 x Microphone, FM Antenna)
LVDS-Display , HDMI
MIPI high speed( Display, Camera 4ch, Camera 2ch, SPI, I2C, GPIO)
UART,SPI,I2C,GPIO, Camera Control (low speed)
Software (OS Images)
OS | Bootloader | Kernel | Release Date | Download | |
|---|---|---|---|---|---|
| 1 | Debian 10.3 | 2020.04 / kuk_imx_v2020.04 | 5.10 / kuk_lf-5.10.y_android-compilable | 2023-05-04 | |
| 2 | Yocto 5.10 Hardknott-Weston-Chromium | 2020.04 / kuk_imx_v2020.04 | 5.10 / kuk_lf-5.10.y_android-compilable | 2023-05-04 |
Initial Setup
In general the Eval-Kit is pre-configured and tested with the OS you ordered.
Please check if all connections are correct.
If needed prepare everything for debug connection by using connector U12. ( for details next chapter)
Plug in the power adapter into the 12V Jack (J17) and 120VAC~240VAC to power source.
The system will start up and OS will be visible on the Display. The Boot messages are printed within the PC terminal window.
Establish a Serial Connection
Connect the baseboard to a computer using the USB-A to micro-USB cable.
You will need a Tera Term application to communicate with the device.
In Tera Term configure the serial connection in Setup-> Serial Port. Set the following settings:
Port: serial port, to which device is connected
Speed: 115200
Data: 8bit
Parity: none
Stop bits: 1
Plug the power connector in, the device will boot up, you should see the terminal output if settings are correct, and correct port is selected.
Links
Carrier-Myon-ConXM ( ConXM, formerly: dragonBase)
SOM-Myon-II-MX8M-Mini (Myon II)