pConXS III + Trizeps VIII Series

Eval-Kit Specification (Without Trizeps Module)

OS	Bootloader	Kernel	Release	Download

OS	Bootloader	Kernel	Release	Download
Windows 10 IoT Enterprise		BSP 1-4-0	1-4-0 2023-04-11	Image
Android
Debian 12	2020.04 / kuk_imx_v2020.04		2024-03-26	Trizeps VIII Mini-pConXS-bookworm
Debian 10.3	2020.04 / kuk_imx_v2020.04	5.10 / kuk_lf-5.10.y_android-compilable	2023-05-26	debian-10.3-lxde
Yocto	2020.04 / kuk_imx_v2020.04	5.10 / kuk_lf-5.10.y_android-compilable	2023-05-30	hardknott_weston_chromium-20230530.imz

OS	Bootloader	Kernel	Release	Download

OS	Bootloader	Release	Download
Windows 10 IoT Enterprise
Android
Debian 12	2020.04 / kuk_imx_v2020.04	2024-03-26	seco_tr8plus-pconxs_bookworm_20240326
Yocto	2020.04 / kuk_imx_v2020.04	2024-04-28	trizeps8plus-pconxs-v3-hardknott_weston_chromium-20230428.imz

In general the Eval-Kit is pre-configured and tested with the OS you ordered.

Please check if all connections are correct.

If needed prepare everything for debug connection by using connector U12. ( for details next chapter)

Plug in the power adapter into the 12V Jack (J17) and 120VAC~240VAC to power source.

The system will start up and OS will be visible on the Display. The Boot messages are printed within the PC terminal window.

Connect the baseboard to a computer using a serial cable and a serial adapter.
You will need a Tera Term application to communicate with the device.
In Tera Term configure the serial connection in Setup-> Serial Port. Set the following settings:
- Port: serial port, to which device is connected
- Speed: 115200
- Data: 8bit
- Parity: none
- Stop bits: 1
Plug the power connector in, the device will boot up, you should see the terminal output if settings are correct, and correct port is selected.